LSL MANTIS-RS PRO LIC.PL.

Why does it actually need a different number plate holder? Probably for "cosmetic" or visual reasons. Whatever the case, the LSL *MANTIS-RS PRO* licence plate holder is exactly what you are looking for. Because in terms of design, it adapts perfectly to the lines of your bike.
The universal LSL *MANTIS-RS PRO* holder can be mounted exactly at the original attachment points of your motorbike. For you, this means: only exchange - no drilling or cutting. The licence plate is made of sheet steel, 2 mm thick and powder-coated. This *PRO* version includes the very small LSL number plate light milled from high-quality aluminium with mounting plate and support arm.

• universal bracket
• suitable for European number plates
• infinitely adjustable angle of inclination
• steplessly adjustable indicator holder
• slotted indicator holder for quick mounting without cable separation
• Continuously adjustable reflector
• simple fixing without further work steps (e.g. drilling)
• Easy mounting of the number plate through slotted holes
• licence plate light incl. holder included in delivery
• Steplessly adjustable licence plate light
• Many different options for mounting the licence plate light
• E-approved

Scope of delivery:
1 x LSL *MANTIS-RS PRO* licence plate holder with licence plate light for various vehicles.
1 x LSL *MANTIS-RS PRO* licence plate holder
Indicator holder
1 x Reflector with adjustable holder
Mounting parts
Assembly instructions


Notes:

• if side reflectors are fitted to your original number plate holder, these must be refitted in a suitable position or replaced with new ones
• to avoid damage to cables, all sharp-edged feed-throughs are protected by a rubber membrane grommet
• stepless adjustment: this allows you to adjust the plate to the desired position without drilling. To keep the plate in this position, there is an additional securing screw
• Two rubber washers are included to secure the plate and reduce vibrations. Another rubber buffer supports the number plate on its underside.
• the indicator brackets of the LSL MANTIS-RS PRO are adjustable in width and therefore suitable for any type of accessory indicator. This allows you to adjust the position of the turn signals to suit a wide range of licence plates.
• The indicator holders are not suitable for original turn signals in most cases.
• To enable the turn signals to be mounted without disconnecting them from the wiring harness, the 10 mm holes are slotted to the side
• the bracket is adjustable in height and designed to allow mounting in the legally required position
• you can also adjust the position of the rear reflector individually via a slider. Adaptation to the different designs of EU number plates is done in no time.