HIGHSIDER FLASHER

HIGHSIDER FLASHER Highsider Nano Flasher Unit

• Extremely small and lightweight flasher unit
• In fact, it's virtually just a cable with a scarcely noticeable plastic cap
• Ideal for conversions with limited space. Installation in the handlebar tube (even if throttle/clutch cables are routed internally), frame tube or wiring harness are all possible
• Load-independent in the range 0.1 W - 84 W
• Suitable for virtually all LED, micro, 10 W and 21 W turn signals

Easy connection via just two cables - simply connected in series
Waterproof and short-circuit-proof

• Operating voltage: 8 V - 18 V
• Dimensions (H x W x D) approx. 5 x 15 x 5.5 mm; length of power cable: 2 x 80 mm

• Note: If your motorcycle only has a single turn signal indicator lamp, or a retrofitted acoustic turn signal indicator, then technical knowledge is required for installing the flasher unit (see Instructions/Guides under "Downloads"), and we recommend using the Kellermann flasher (Order no. 10032036).
• As an alternative, you can use a resistor for each LED turn signal. If you are replacing 4 x 21 W original turn signals with 1 W -2 W LED turn signals, you should install 4 resistors, Order no. 10032063.

• Important! Not suitable for use with hazard warning lamp systems!